WEST APPLIANCE SERVICE

AC Running but Not Cooling During a Los Angeles Heat Wave

When your AC runs but doesn't cool, the most common causes are a clogged air filter, a frozen evaporator coil, a dirty or failing outdoor unit, or low refrigerant from a leak. During a Los Angeles heat wave, an older or undersized system can also fall behind the heat even when nothing is broken. This guide covers what you can safely check yourself and which signs point to a failed part. It also explains when to shut the system off and call a technician.

Technician repairing a Carrier furnace

By West Appliance Service ·

Start with the thermostat and air filter

Before assuming a major failure, confirm the thermostat is set to Cool and the setpoint is below the room temperature. Also check that the fan is set to Auto rather than On. With the fan on On, the blower keeps running between cooling cycles and can push warm, humid air through the vents, which feels like the AC stopped working. If the thermostat runs on batteries, replace them, because weak batteries can cause erratic behavior. Next, pull the air filter. A filter caked with dust restricts airflow across the indoor coil, which reduces cooling and can eventually freeze the coil. During a heat wave the system runs nearly nonstop, so a filter that looked fine a month ago can clog quickly. This happens faster in homes with pets or nearby construction. Replace it with the size printed on the frame. Then make sure supply and return vents are open and not blocked by furniture, curtains or rugs.

Look for a frozen indoor coil

Weak airflow from the vents can mean the evaporator coil has frozen. So can frost on the indoor coil or ice on the copper refrigerant line near the outdoor unit. Ice blocks airflow, so the system runs constantly while the house keeps warming. Common causes include a dirty filter, blocked return vents, a failing blower motor and low refrigerant. To thaw it, set the thermostat to Off and the fan to On, which moves room air across the coil. Thawing often takes several hours, and the melting ice can overflow the drain pan, so put towels down around the indoor unit. Do not chip at the ice. The coil fins and tubing damage easily, and a puncture creates a refrigerant leak. Once the coil has thawed and you have installed a fresh filter, try cooling again. If the coil freezes a second time, the cause is usually low refrigerant or a blower problem, and it needs a technician.

Check the outdoor unit safely

Go outside while the thermostat is calling for cooling. The large fan on top should be spinning, and you should hear the compressor running. A failed capacitor or fan motor is a common cause if the fan is still or the unit hums without starting. Heat waves tend to expose parts that were already weak. Check the breaker in your main panel and the disconnect box near the unit. If a breaker has tripped, you can reset it once. If it trips again, leave it off, because that points to an electrical or mechanical fault. To clean the outdoor coil, first turn off power at the disconnect. Then clear leaves and debris and gently rinse the fins with a garden hose at low pressure, never a pressure washer. In the beach cities, salt air can corrode coils and electrical connections faster than it does inland. Do not open the unit's electrical compartment. Capacitors can hold a dangerous charge even with the power off.

Signs of a refrigerant leak

Air conditioners do not use up refrigerant. If the charge is low, there is a leak somewhere in the system. Signs include: - Air from the vents that feels cool but not cold - Long run times that never reach the setpoint - Ice on the larger copper line - A hissing or bubbling sound - Oily residue at fittings Topping off refrigerant without finding the leak only buys time, and the system often ends up low again. Refrigerant work is not a DIY job. Handling refrigerant requires EPA certification, liquid refrigerant can cause frostbite on contact, and the system operates under high pressure. A technician can locate the leak and judge whether a repair makes sense for the age of the equipment. They can then recharge the system to the correct level. Running a system low on refrigerant for long periods can overheat the compressor. The compressor is usually the most expensive part to replace.

When the system works but can't keep up with the heat

Many residential systems are sized for typical summer days, not record heat. When outdoor temperatures climb well past normal, a healthy system may run all afternoon and still sit a few degrees above the setpoint. This is common in older coastal homes, where air conditioning was often added later and ductwork may run through hot attics. To help the system keep up: - Close blinds on sun-facing windows. - Avoid using the oven and dryer during peak afternoon hours. - Keep interior doors open so air can return to the system. - Precool the house in the morning to give the system a head start. Setting the thermostat very low does not cool the house faster. It only makes the system run longer. If the air at the vents feels noticeably cool and the house recovers in the evening, the system may simply be at its limit. If the vents blow warm or room-temperature air, look for a failure instead.

Common questions

Why is my AC blowing warm air when the fan is running?

Most often the outdoor unit is not running properly while the indoor blower keeps moving air. The usual causes are a tripped breaker, a failed capacitor or a stopped condenser fan. Low refrigerant or a thermostat fan set to On can cause the same symptom. Check the breaker and thermostat first, then call a technician if the outdoor unit still isn't running.

Should I turn off my AC if it's not cooling?

Yes, if you see ice on the lines or coil, hear grinding or loud buzzing, smell burning, or the outdoor unit hums while its fan stays still. Running the system in those conditions can damage the compressor. Set the thermostat to Off, use the fan setting to thaw any ice, and have the system inspected before running it again.

How long should an AC take to cool a house?

On a normal day, a working system usually lowers the indoor temperature steadily and cycles off once it reaches the setpoint. During a heat wave it may run for hours without stopping, which can be normal. If the temperature never drops at all, or keeps rising while the system runs, something is likely wrong beyond the heat.

Many no-cooling problems start with simple fixes like a new filter, a reset breaker or a thawed coil. If the house still won't cool, the breaker keeps tripping, or the coil freezes again, call a professional. West Appliance Service is open 24/7 and offers same-day visits when the schedule allows. Call (877) 775-4968. The $95 diagnosis is credited toward the repair, and repairs come with a 90-day warranty.

Something stopped working? We're open 24/7.